Reference Tissue Models

<< Click to Display Table of Contents >>

Navigation:  Introduction to Modeling in PET >

Reference Tissue Models

The measurement and analysis of the blood samples for kinetic modeling is an invasive and demanding procedure. Therefore, methods have been developed to obviate the need for invasive blood sampling. The solutions found replace the arterial input curve by an indirect input curve, namely the time activity curve of some reference tissue. Therefore they are called reference methods. Reference methods are not able to provide a full kinetic analysis. However, assuming certain relations between the kinetics of the tissue of interest and the reference tissue, they can provide valuable measures of interest.

Most of these reference methods are dedicated to reversibly binding neuroreceptor tracers. A reference tissue must be found which is devoid of receptors, and then it is assumed that the distribution volume of the non-displaceable compartment (free tracer in tissue and non-specific binding) is the same among the tissues. Under these assumptions a measure of the receptor concentration called binding potential can be calculated from the two time-activity curves.

Model Structure

The compartment models are usually based upon the following configuration:

picture_6490

In the model equations C'(t) represents the TAC from the reference region (k3=0 in the 2-tissue compartment model), and C(t) the TAC from a receptor-rich region (k3>0).

However, the various reference methods differ in their mathematical approaches, and they show substantial differences with regard to noise sensitivity and processing speed. They are described in the PKIN Model Reference section.