Cine Control

<< Click to Display Table of Contents >>

Navigation:  MIP Page >

Cine Control

Image Display Selection

Per default, all the input MIPs as well as the fusion MIP are rotated. However, there is a choice in the lower left which allows showing subsets of these images.  

picture_9210

picture_9207

Show the three input MIPs as well as the fusion MIP (default).

picture_9206

Show only the three input MIPs.

picture_9209

Show only the fusion MIP.

Projection Calculation

Calculation of the configured projections is started with the picture_9213 button. After the calculation is completed, the rotation cine is immediately started.

Cine Controls

The direction of the cine, the speed and the behavior after a rotation can be configured with the usual cine control elements.

picture_9208

If any of the image presentation options is activated, the cine stops. However, in most cases a projection recalculation is not required, so the rotation can be simply restarted.

Maximizing the Display Area

In order to maximize the image area for watching the cine, the controls can be minimized with the show/hide taskbar button indicated below. They are recovered by activating the same button again.  

picture_9218

Movie Generation

In order to create a movie file, the picture_9215 button has to be activated and then the cine started. A dialog window is shown for configuring the movie format QuickTime, Animate GIF or DICOM.

picture_9216

The movie will be assembled from JPEG files which are saved to a folder which is to be configured in the lower part. The JPEG images may be persistent, depending on the Delete JPEG files option.

After activating the Start button, the JPEG images corresponding to the different angles are written to disk and a dialog window opened defining a location and a name for the movie file.