Data Profiles on Caps

<< Click to Display Table of Contents >>

Navigation:  3D Rendering Page > Cutting away Parts of the VR or SR Information > By Oblique Planes >

Data Profiles on Caps

When a Cap is created during the cutting by an oblique plane procedure, data profiles can be generated using the dedicated button located at the bottom of the Cap panel:

P3D_CuttingCap

The Visible box determines whether or not the Cap is shown into the scene

The texture selection allows to switch off texturing (No Texture), or to select one of the loaded image series for coloring the surface. Int enables interpolation of the texture information. If no texture is active, the cap color can be defined using the Color selection.

The Name field allows to personalized the Cap entry name in the View tree. Select the Cap entry in the View tree, enter the Name and use the Set button to rename.

Select the data profile resolution from the available entries in the list and finally activate the Generate data profile. The data profiles can be used for setting the boundary conditions during the CFD simulation. Please refer to the PGEM documentation for further information about the CFD simulation.